MM-94


Motor-drive Manipulator

MM-94:  $5,718.92
This motor-drive coarse manipulator is used to position a pipette within the microscope's field of view, where it can then be micromanipulated more precisely with a fine hydraulic micromanipulator such as the MMO-4. It is controlled remotely using the electronic joystick. The Z-axis moves at double the speed of X/Y-axis, to facilitate changing samples rapidly. The MM-94 includes the drive unit for right-sided use, the joystick controller, and a dual control unit / power supply.
* The MM-94 is the model for right-sided use, while the MM-94B is for left-sided use.
For a full setup, with manipulation on both sides, you can add the MM-94B, and the two units can share the same control unit / power supply that comes with the MM-94.



For a smaller footprint on your microscope table, the MM-94 control box can be held vertically with the use of the control box stand (PS-1).

Specification
Accessories included Power cord, Hex Wrench
Movement range Coarse X22mm, Y22mm, Z22mm
Driving speed X/Y Axis 1.4mm/s (with use of high-speed button)
Maximum speed 0.7mm/s (with use of speed adjusting knob)
Minimum speed 0.1mm/s (with use of speed adjusting knob)
Z Axis2.8mm/s (with use of high-speed button)
Maximum speed 1.4mm/s (with use of speed adjusting knob)
Minimum speed 0.2mm/s (with use of speed adjusting knob)
Power consumption Approx. 10W
Dimensions/Weight Control unit W204 x D135 x H62mm, 1.05kg
Controller W70 x D100 x H120mm, 530g, Connecting cable (1.2m)
Drive unit W85 x D112 x H144mm, 591g, Connecting cable (1.2m)

† These are our list prices. If you are paying with an Institutional Purchase Order or by check, you qualify for a 7.5% discount. Click here to change your payment method and see the lower prices.