PN-31


Magnetic Glass Microelectrode Horizontal Needle Puller

PN-31:  $4,162.16 - Ships in 1-5 days
Narishige's PN-31 is nearly identical to the discontinued PN-30 puller and is used for producing long, thin, sharp microneedles.


This puller uses a pulling method by which a glass capillary is fine-drawn using electromagnetic force. The long draw-out volume and employment of a strong electromagnetic solenoid enable the production of long, sharp microcapillary needles. The pulling tension can be adjusted over a wide range, from weak tension for gradual pulling of the glass capillary at the beginning to strong tension for the single-stretch draw-out required to make a long, thin microneedle. The heater uses a platinum plate which heats up quickly, so pulling can begin immediately, with minimal time-lag. Digital values, with the maximum output of the electromagnet and heater represented as 100, are shown on the display, making it easier to mass-produce large quantities of identical glass needles of uniform quality.

The PN-31 can run on any AC voltage from 100 - 240 and uses approximately 250 watts.
Dimensions (mm): W300 x D190 x H230. Weight: 7.7kg.

Available replacement heating elements:
PN-3H for 3mm
PN-30H for 6mm

Specification
Accessories includedGlass Capillary with filament
Spare Heater
Heater Reshaping Tool
AC Power Cord
Allen Wrench
Power SourceAC100 (±5%), 50/60Hz
AC120 (±5%), 50/60Hz
AC220 (±5%), 50/60Hz
AC240 (±5%), 50/60Hz
Power consumptionApprox. 250W
Heater level100 = heater voltage 1V
Magnet level100 = magnetic voltage 36V
Dimensions/WeightW300 × D190 × H230mm, 7.7kg

† These are our list prices. If you are paying with an Institutional Purchase Order or by check, you qualify for a 7.5% discount. Click here to change your payment method and see the lower prices.