Holder for using silicon neural probes with SMM series

SMM-HA:  $356.76 - Ships in 5-10 days
Holder for Neural Probes

Holder made for using silicon probes with SMM series products

This holder is intended to hold a silicon probe on SMM series products. The silicon probe can be affixed close to the holder shaft to prevent interference around the probe. The holding section is made with resin - thus it does not conduct electricity when in contact with a substrate. (The photograph above shows the holding of a silicon probe by NeuroNexus.)

Holders for SMM Series

DescriptionAttachmentHolder for Neural ProbesHolder for Neural ProbesCannula HolderMultiuse Holder


Accessories includedHex Wrench
Fixing Knob
Set Screw × 2
Dimensions/WeightW13 × D12 × H222mm, 90g
Applicable silicon probesThickness: 2mm or less
Width: within 2.5 ~ 5mm
Length: 12mm or longer

† These are our list prices. If you are paying with an Institutional Purchase Order or by check, you qualify for a 7.5% discount. Click here to change your payment method and see the lower prices.